Why did my Aimfox follow-up messages drop?
The Aimfox help pages give 4 common reasons. The first to rule out: A sequence stops for a lead as soon as they reply, so more replies can mean fewer automated follow-ups.
Is it broken, or just quiet?
A number can fall because fewer people came, or because something stopped counting them. Below are the causes the Aimfox help pages give, and how to check each one yourself.
What causes it?
A sequence stops for a lead as soon as they reply, so more replies can mean fewer automated follow-ups.
In the Aimfox help:
Sequences are immediately stopped as soon as Aimfox detects a reply from your target.
How Aimfox Campaigns work, read 2026-11-12.In a campaign that starts with a connection request, follow-up messages go only to people who accepted it, so fewer acceptances can mean fewer messages.
In the Aimfox help:
Messages are sent only to leads who have accepted your connection requests.
How Aimfox Campaigns work, read 2026-11-12.Leads whose invite is still pending wait before any further step, which can hold messages back.
In the Aimfox help:
While a connection request is pending, Aimfox pauses further actions for that profile.
How Aimfox Campaigns work, read 2026-11-12.Campaign steps run only inside the days and hours set for the campaign, so a narrow schedule can lower daily message counts.
In the Aimfox help:
The system will only send connection invites and perform campaign actions within the configured days and hours.
How Aimfox Campaigns work, read 2026-11-12.
How do I check it myself?
Check the delay set before each message in the sequence, since a long delay holds the next message back.
In the Aimfox help:
Every message in the sequence can be delayed for as long as you want
How Aimfox Campaigns work, read 2026-11-12.Give a newly launched campaign time to finish its first processing cycle before judging its message numbers.
In the Aimfox help:
Allow time for the initial processing cycle to complete before evaluating campaign performance
Optimizing your campaign sending volumes, read 2026-11-12.
How does Aimfox work with Feder?
- Connect Aimfox to Feder and it joins your Reach apps.
- When you connect Aimfox, Feder checks the connection straight away and shows Connected only when that check passes. If a reading cannot be taken later, Feder shows it as not read, never as zero.
Some numbers are too quiet to judge daily, such as a form filled in a few times a week. Until there is enough of your own history to judge a change, Feder says it is still learning and scores nothing, rather than guessing.
See whether you can trust the numbers in Aimfox, one of your Reach apps. Feder only reads. It never changes anything in Aimfox.
What else goes wrong with these numbers?
- Why is Aimfox sending fewer connection requests each day?Aimfox
- Why are fewer leads getting into my Aimfox campaign?Aimfox
- Why did Google Analytics stop collecting data?Google Analytics
- Why aren't my key events showing in Google Analytics?Google Analytics
- Why does Google Analytics show (not set)?Google Analytics
See every question.
Where do these answers come from?
Every cause and check on this page comes from the Aimfox help pages, quoted above with the date we read them. Last reviewed 2026-11-12. We read them again by 2027-11-12. If one changes, this page changes or comes down.