Why are numbers missing in Adaptive Planning after a scheduled data load?
The Adaptive from Workday help pages give 3 common reasons. The first to rule out: When a loader runs in replace mode, cells in the load's scope that the new data does not match are deleted.
Is it broken, or just quiet?
A number can fall because fewer people came, or because something stopped counting them. Below are the causes the Adaptive from Workday help pages give, and how to check each one yourself.
What causes it?
When a loader runs in replace mode, cells in the load's scope that the new data does not match are deleted.
In the Adaptive from Workday help:
Any existing cell within the import scope that isn't matched in the new data (payload) will be deleted.
Create Planning Data Loaders, read 2026-11-12.A row with an empty account or level makes the loader finish with a failed status.
In the Adaptive from Workday help:
Any row that contains an empty account/level value causes the loader to complete with a Failed status.
Create Planning Data Loaders, read 2026-11-12.Each loader covers a set range of time periods, so a period outside that range is not loaded.
In the Adaptive from Workday help:
The period parameter specifies the range of time periods for which data will be loaded into Adaptive Planning.
Create Planning Data Loaders, read 2026-11-12.
How do I check it myself?
Check the integration task's log; at its basic level it records information such as when the data source was updated.
In the Adaptive from Workday help:
Logs all basic information, such as when the data source was updated.
Create Integration Tasks, read 2026-11-12.Check the time zone a scheduled task runs in, so you know which day each load lands on.
In the Adaptive from Workday help:
Select the time zone of the time to run the task.
Create Integration Tasks, read 2026-11-12.Look at a loader's logs soon after the load, since they are erased after a week.
In the Adaptive from Workday help:
Logs automatically erase after a week.
Create Planning Data Loaders, read 2026-11-12.
How does Adaptive from Workday work with Feder?
- Connect Adaptive from Workday to Feder and it joins your Money apps.
- When you connect Adaptive from Workday, Feder checks the connection straight away and shows Connected only when that check passes. If a reading cannot be taken later, Feder shows it as not read, never as zero.
Some numbers are too quiet to judge daily, such as a form filled in a few times a week. Until there is enough of your own history to judge a change, Feder says it is still learning and scores nothing, rather than guessing.
See whether you can trust the numbers in Adaptive from Workday, one of your Money apps. Feder only reads. It never changes anything in Adaptive from Workday.
What else goes wrong with these numbers?
- Why did numbers in Adaptive Planning change after an import?Adaptive from Workday
- Why is a total lower in my Adaptive Planning report or export?Adaptive from Workday
- Why did Google Analytics stop collecting data?Google Analytics
- Why aren't my key events showing in Google Analytics?Google Analytics
- Why does Google Analytics show (not set)?Google Analytics
See every question.
Where do these answers come from?
Every cause and check on this page comes from the Adaptive from Workday help pages, quoted above with the date we read them. Last reviewed 2026-11-12. We read them again by 2027-11-12. If one changes, this page changes or comes down.